Mercury HP MP9110S
Extension Battery Pack
EMI Filter and Cold Start
Wide input voltage range
UPS startup without battery
LCD & load capacity display
Lightning & Surge protection
Advanced Battery Management
Fully digitized microprocessor control
Fan speed auto control when load varies
Advanced battery charge in UPS OFF Mode
Smart RS232 Communication with monitoring software
High Frequency and Double conversion online technology
INPUT
Nominal Voltage 220VAC / 240VAC
Voltage Range 140VAC-300VAC
Frequency 50/60Hz
Phase Single Phase
Socket Built in cable with fuse
Cold Start Press the ON/OFF switch (0%-100% load)
OUTPUT
Output Voltage 220VAC / 240VAC
Voltage Regulation Battery mode: ±10%
Waveform Battery mode: Simulated sinewave / AC mode: Synchronize with input
Rating Frequency Line mode: Synchronize with the utility / Battery mode: 50Hz/60Hz
Rear Output Socket Battery backup: 4 x Universal
BATTERY
Battery Type 12V/9AH x 2
Charging Time 6-8 hours to recover to 90% capacity
Charge Current Normal mode: About 1A
Charging Voltage 27.4VDC
SYSTEM FEATURES
Transfer Time 4-8ms
Audible Alarm Battery mode: Sounding every 10 sec / Battery low: Sounding every 1 sec / Overload: Sounding every 0.5 sec / Fault: Continuous sounding
LED INDICATIONS
Line Mode Green lighting
Battery Mode Yellow flashing
Fault Red lighting
SHORT CIRCUIT PROTECTION
Line Mode Fuse and firmware protection
Battery Mode Software protection controlled by firmware
OVERLOAD PROTECTION
Line Mode Load>110%+20%/-10% after 5 minutes and go to fault.
Battery Mode Load>120%+20%/-10% shut down immediately and go to fault, Load>100%+10%/-10% shut down immediately.
ENVIRONMENTAL
Humidity 0-90% Relative Humidity 0-40˚C (Non-condensing)
Noise Level Less than <45dB
PHYSICAL
Dimension W x D x H (mm) 390 x 125 x 225, Master carton: 460 x 375 x 333 (2pcs)
Net Weight (kgs) 12.7±0.3
